Certification: CE, FCC ID: N4ZFGR4P00
CH 1-CH 4: Connect servos, power supply or other components
i-BUS: for channel expansion or connecting sensors
BIND: For tie cables
Battery: Connect the battery
Binding:
1. Insert the tie cable into the receiver tie port
2. Plug the power cord into another port, and the receiver LED will start blinking rapidly indicating that it has entered bind mode
3. Put the transmitter into bind mode; (See the transmitter instruction manual for more information)
4. Binding is successful when the receiver LED will stop flashing
Disconnect the power cord and tie it from the receiver.
5. Reconnect the power cord to the receiver
6. Check to make sure that the transmitter and receiver are working as expected, if there is any problem or unexpected operation, follow the steps above to tie again.
Attention:
Make sure the product is installed and calibrated properly, failure to do so could result in serious injury.
Ensure that the receiver battery is disconnected before turning off the transmitter, failure to do so may result in undesired operation or loss of control.
Ensure that the receiver is installed away from motors, electronic speed controllers, or any other device that makes excess electrical noise.
Keep receiving antennas at least 1 cm away from conductive materials such as carbon or metal.
Do not turn on the receiver during the setup process to prevent loss of control.
Package Contents:
1 x FGr4P Receiver